Subaru Legacy BN/BS (2015-2019) Service Manual: Clear memory mode operation

Subaru Legacy BN/BS (2015-2019) Service Manual / Vehicle dynamics control (vdc) (diagnostics) / Clear memory mode operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System Check».

4. On «Select System» display, select «Brake Control System».

5. On «Select Function» display, select «DTC».

6. On «DTC» display, select «Clear Memory».

NOTE:

For detailed operation procedures, refer to “Application help”.

Basic diagnostic procedure procedure

CAUTION:Remove foreign matter (dust, water, oil etc.) from the VDCCM&H/U connector during removal and installation.NOTE:• To check the harness for open or short circuits, shake problem spot or c ...

Electrical component location location

(1)VDC control module and hydraulic control unit (VDCCM&H/U)(6)Brake light relay(10)Hill hold switch(2)VDC OFF switch(7)Magnetic encoder(11)Engine control module (ECM)(3)Combination meter(8)ABS wheel ...

Other materials:

Assembly
1. Check each part. Front Disc Brake Assembly > INSPECTION2. Clean the inside of the caliper body using brake fluid.Fluid:FMVSS No. 116, DOT3 or DOT43. Install the piston seal and the piston - disc brake.(1) Apply a coat of brake fluid to piston seal and install the piston seal to the groove inside ...