Subaru Legacy BN/BS (2015-2019) Service Manual: Crankshaft position sensor plate

Installation

1. Install the crankshaft position sensor to the cylinder block, and connect the connector to the crankshaft position sensor.Tightening torque:6.4 N·m (0.7 kgf-m, 4.7 ft-lb)2. Install the air i ...

Removal

The crankshaft position sensor plate is tightened together with the drive plate or flywheel; therefore, refer to “Drive Plate” or “Flywheel” for removal procedure. Drive Plate ...

Other materials:

Dtc p2273 o2 sensor signal biased/stuck rich bank 2 sensor 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...