Subaru Legacy BN/BS (2015-2019) Service Manual: Fuel injection (fuel systems)(h4do)
Subaru Legacy BN/BS (2015-2019) Service Manual / Fuel injection (fuel systems)(h4do)
- Fuel procedure
- Fuel system trouble in general inspection
- Throttle position sensor specification
- Tumble generator valve specification
- Tumble generator valve actuator specification
- Camshaft position sensor
- Crankshaft position sensor
- Crankshaft position sensor plate
- Electronic throttle control relay
- Engine control module (ecm)
- Engine coolant temperature sensor
- Engine oil temperature sensor
- Engine wiring harness
- Front oxygen (a f) sensor
- Fuel delivery and evaporation lines
- Fuel filler pipe
- Fuel filter
- Fuel injector
- Fuel level sensor
- Fuel pump
- Fuel pump relay
- Fuel sub level sensor
- Fuel tank
- Fuel tank protector
- General description
- Intake manifold assembly
- Knock sensor
- Main relay
- Manifold absolute pressure sensor
- Mass air flow and intake air temperature sensor
- Oil control solenoid
- Rear oxygen sensor
- Throttle body
Adjustment
CAUTION:When the wheel alignment has been adjusted, perform the following adjustment.– Lane keep assist learning value clear (model with EyeSight): Clear Active Lane Keep System Learning Value > O ...
Fuel procedure
1. RELEASING OF FUEL PRESSUREWARNING:Place “NO OPEN FLAMES” signs near the working area.CAUTION:Be careful not to spill fuel.1. Remove the fuse of fuel pump from main fuse box.2. Start the ...
Other materials:
Disassembly
1. BUSHING A - TRAILING LINKUsing the ST, push out the bushing A - trailing link.Preparation tool:ST-A: INSTALLER (899874100)ST-B: PRESS (499755602)2. BUSHING - TRAILING LINKFor the removal procedure of bushing - trailing link, refer to “Rear Axle” in the “DRIVE SHAFT SYSTEM” ...
© 2017-2026 Copyright www.sulegacy.com
