Subaru Legacy BN/BS (2015-2019) Service Manual: Front oxygen (a f) sensor

Installation

1. Set the engine wiring harness to the engine, and connect the connector.NOTE:• If the clip is damaged, replace it with a new part.• Before replacing the clip, put an alignment mark (a) o ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle.3. Remove the under cover. Front Under Cover > REMOVAL4. Disconnect the front oxygen (A/F) sensor connector, and rem ...

Other materials:

Assembly
1. Bend the claws while pushing the weather strip - door INN against the trim panel - door so that there is no gap.CAUTION:Beware of the direction of folding the claws.(a)Rivet(b)Direction of folding claws 2. Install the rivet, and apply unwoven cloth tape over the rivet crimped section.CAUTION:&bu ...