Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Fuel injection (fuel systems)(h4do) / Engine coolant temperature sensor / Installation

1. Install the engine coolant temperature sensor, and connect the connector to the engine coolant temperature sensor.

NOTE:

Use a new gasket.

Tightening torque:

18 N·m (1.8 kgf-m, 13.3 ft-lb)

2. Connect the ground terminal to battery sensor. NOTE

3. Fill engine coolant. Engine Coolant > REPLACEMENT

Inspection

1. Check that the engine coolant temperature sensor has no deformation, cracks or other damages.2. Immerse the engine coolant temperature sensor and a thermometer in water.CAUTION:Take care not to all ...

Engine oil temperature sensor

...

Other materials:

Driving tips
NOTE If the accelerator and brake pedals are depressed at the same time, driving torque may be restrained. This is not a malfunction. Do not drive with your foot resting on the clutch pedal and do not use the clutch to hold your vehicle at a standstill on an upgrade. Either of those actions ...