Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Fuel injection (fuel systems)(h4do) / Throttle body / Installation

1. Install the throttle body to the intake manifold assembly.

NOTE:

Use a new gasket.

Tightening torque:

8 N·m (0.8 kgf-m, 5.9 ft-lb)

2. Connect the connector to the throttle position sensor.

3. Connect the preheater hoses to the throttle body.

4. Install the air intake boot. Air Intake Boot > INSTALLATION

5. Connect the ground terminal to battery sensor. NOTE

6. Fill engine coolant. Engine Coolant > REPLACEMENT

Inspection

1. THROTTLE SENSOR (METHOD WITH CIRCUIT TESTER)1. Disconnect the ground terminal from battery sensor. NOTE2. While pressing the section (A) shown in the figure, move the lock lever (B) in the directi ...

Fuel injection (fuel systems)(h6do)

...

Other materials:

Installation
CAUTION:• Make sure the electrical connector is connected securely.• Make sure that each meter operates normally.• When the combination meter assembly of the model without keyless access with push button start has been replaced, perform the registration of immobilizer. (Except for ...