Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • Make sure the electrical connector is connected securely. • Make sure that each meter operates normally. • When the combination meter assembly of the model without keyless access with push button start has been replaced, perform the registration of immobilizer. (Except for C0 and C5 models) For the relevant procedures, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER”. • When the combination meter is replaced, perform the variant work. Combination Meter System > OPERATION 1. Install the combination meter assembly. Tightening torque: 7 N·m (0.7 kgf-m, 5.2 ft-lb) 2. Install the visor assembly - lower. 3. Install the cover assembly - instrument panel LWR driver. 4. Connect the ground terminal to battery sensor. NOTE |
Assembly
1. Install the lens.2. Install the outer mask. ...
Disassembly
CAUTION:• Use gloves to avoid damage and putting fingerprints on the lens surface and meter surfaces.• Be sure not to touch the meter indicator needle.• Because LEDs are used for all ...
Other materials:
Dtc p2757 torque converter clutch pressure control solenoid control circuit performance/stuck off
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:No lock-up occurs.1. ENGINE TYPE FBWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK DTC.Read the DTC using Subaru Select Monitor.Besides DTC P2757, is any ...
