Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Fuel injection (fuel systems)(h4do) / Engine oil temperature sensor / Installation

1. Install the engine oil temperature sensor to the chain cover, and connect the connector to the engine oil temperature sensor.

NOTE:

Use a new gasket.

Tightening torque:

18 N·m (1.8 kgf-m, 13.3 ft-lb)

2. Connect the ground terminal to battery sensor. NOTE

Inspection

1. Check that the engine oil temperature sensor has no deformation, cracks or other damages.2. Immerse the engine oil temperature sensor and a thermometer in water.CAUTION:Take care not to allow water ...

Engine wiring harness

...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - front pillar UPR. Upper Inner Trim > REMOVAL3. Release the clips and claws, then detach the grille speaker side. Front Speaker > REMOVAL4. Remove the sunload sensor.(1) Release the claws of the grille - front de ...