Subaru Legacy BN/BS (2015-2019) Service Manual: Engine wiring harness

Installation

1. Install the engine oil temperature sensor to the chain cover, and connect the connector to the engine oil temperature sensor.NOTE:Use a new gasket.Tightening torque:18 N·m (1.8 kgf-m, 13.3 f ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the intake manifold assembly. Intake Manifold Assembly > REMOVAL3. Disconnect each connector to remove the engine wiring harness. ...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle.3. Disconnect the connector (A) of the front oxygen (A/F) sensor.4. Remove the clip (B) securing the front oxygen (A/F) sensor harness. (LH side only)5. Apply spray-type lubricant (004301003) or equivalent to the thre ...