Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Fuel injection (fuel systems)(h4do) / Engine wiring harness / Inspection

Check that the engine wiring harness does not have deformation, cracks and any other damage.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the intake manifold assembly. Intake Manifold Assembly > REMOVAL3. Disconnect each connector to remove the engine wiring harness. ...

Installation

1. Set the engine wiring harness to the engine, and connect the connector.NOTE:• If the clip is damaged, replace it with a new part.• Before replacing the clip, put an alignment mark (a) o ...

Other materials:

Inspection
1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 22 — 3Always1.82±0.07 -2. Replace the resistor assembly - daytime running light if the inspection result is not within the standard. ...