Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Fuel injection (fuel systems)(h4do) / Oil control solenoid / Installation

1. Install the intake oil control solenoid to the chain cover, and connect the connector to the intake oil control solenoid.

NOTE:

• Use new O-rings.

• Apply engine oil to O-ring.

Tightening torque:

6.4 N·m (0.7 kgf-m, 4.7 ft-lb)

2. Install the air intake duct. (RH side only) Air Intake Duct > INSTALLATION

3. Connect the ground terminal to battery sensor. NOTE

Inspection

1. Check that the oil control solenoid has no deformation, cracks or other damages.2. Measure the resistance between the oil control solenoid terminals.Terminal No.Standard1 and 27.25±0.4 - (when 20& ...

Rear oxygen sensor

...

Other materials:

Electrical specification
NOTE:The terminal numbers of the power steering control module connectors are as indicated in the figure.ContentConnector No.Terminal No.Input/output signalMeasured value and measuring conditionsPower supply (IG SW)B4505Battery voltage is detected with the ignition switch ON when measuring between ( ...