Subaru Legacy BN/BS (2015-2019) Service Manual: Rear oxygen sensor

Installation

1. Install the intake oil control solenoid to the chain cover, and connect the connector to the intake oil control solenoid.NOTE:• Use new O-rings.• Apply engine oil to O-ring.Tightening t ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle.3. Remove the under cover. Front Under Cover > REMOVAL4. Disconnect the rear oxygen sensor connector.(A)Front oxygen ...

Other materials:

Dtc p0030 a/f / o2 heater control circuit bank 1 sensor 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...