Subaru Legacy BN/BS (2015-2019) Service Manual: Mass air flow and intake air temperature sensor

Installation

1. Install the manifold absolute pressure sensor to the intake manifold assembly, and connect the connector to the manifold absolute pressure sensor.NOTE:Use new O-rings.Tightening torque:3.4 N· ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the mass air flow and intake air temper ...

Other materials:

Inspection
1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 2Switch OFF1 M- or moreSwitch ONLess than 1 -2. Replace the power rear gate inner switch, if the inspection result is not within the standard value. ...