Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Fuel injection (fuel systems)(h4do) / Camshaft position sensor / Installation

1. Install the camshaft position sensor to the chain cover, and connect the connector to the camshaft position sensor.

NOTE:

• Use new O-rings.

• Apply engine oil to O-ring.

Tightening torque:

6.4 N·m (0.7 kgf-m, 4.7 ft-lb)

2. Install the air intake duct. (RH side only) Air Intake Duct > INSTALLATION

Inspection

1. CAMSHAFT POSITION SENSOR1. Disconnect the ground terminal from battery sensor. NOTE2. Prepare an oscilloscope.3. While pressing the section (A) shown in the figure, move the lock lever (B) in the ...

Crankshaft position sensor

...

Other materials:

Installation
CAUTION:Make sure that the harness grommet is securely installed.If not properly installed, this may cause leaks.1. Install the rear lock button and the switch - opener rear gate.2. Install the garnish assembly - rear gate. Rear Gate Garnish > INSTALLATIONTightening torque4.5 N·m (0.4 kgf-m, ...