Subaru Legacy BN/BS (2015-2019) Service Manual: Camshaft position sensor

Tumble generator valve actuator specification

The tumble generator valve actuator must not be removed from the intake manifold assembly since it is integrated in the intake manifold assembly.Refer to “Intake Manifold Assembly” for rem ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the air intake duct. (RH side only) Air Intake Duct > REMOVAL3. Disconnect the connector (A) from the camshaft position sensor, a ...

Other materials:

Inspection
1. CLUTCH START SWITCH1. Perform the following inspections. If the clutch start switch does not operate normally, adjust the switch, and check it again. Clutch Switch > ADJUSTMENT• Make sure that engine does not start with clutch pedal not depressed.• Make sure that engine starts with c ...