Subaru Legacy BN/BS (2015-2019) Service Manual: Disassembly
1. Remove the snap ring.
2. Remove the ball bearing.
3. Remove the snap ring from transfer drive gear, and remove the needle bearing. |
Inspection
1. Ball bearingReplace the ball bearing in following cases.• In case of broken or rusty ball bearings• In case of worn or damaged ball bearings• When the ball bearings fail to turn s ...
Other materials:
Dtc p2271 o2 sensor signal biased/stuck rich bank 1 sensor 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...
© 2017-2026 Copyright www.sulegacy.com
