Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc b1435 evaporator temperature sensor circuit short-circuit

DTC DETECTING CONDITION:

Evaporator sensor circuit is shorted.

TROUBLE SYMPTOM:

Compressor does not operate. (Variable compressor)

Evaporator temperature is falsely recognized as high, and the compartment temperature is adjusted.

WIRING DIAGRAM:

Air conditioning system Air Conditioning System > WIRING DIAGRAM

STEPCHECKYESNO

1.CHECK CONNECTOR.

1) Check connecting condition of the A/C CM connector and evaporator sensor connector.

2) Read the DTC using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)

Is B1435 displayed-

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1435 EVAPORATOR TEMPERATURE SENSOR CIRCUIT SHORT-CIRCUIT

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE:

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

2.CHECK EVAPORATOR SENSOR.

1) Disconnect the evaporator sensor.

2) Read the DTC of the A/C CM using the Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)

Is B1434 displayed-

Replace the evaporator sensor. Evaporator > REMOVAL

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1435 EVAPORATOR TEMPERATURE SENSOR CIRCUIT SHORT-CIRCUIT

3.CHECK HARNESS.

1) Turn the ignition switch to ON.

2) Using the tester, measure the voltage between terminals.

Connector & terminal

(i172) No. 1 (+) — No. 2 (−):

Is the voltage 4.5 — 5.0 V-

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE:

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1435 EVAPORATOR TEMPERATURE SENSOR CIRCUIT SHORT-CIRCUIT

4.CHECK HARNESS (SHORTED BETWEEN LINES).

1) Disconnect the connector from A/C CM.

2) Using a tester, check continuity between terminals.

Connector & terminal

(i172) No. 1 — No. 2:

Is there continuity-

Repair or replace the short circuit of the harness.

Replace the A/C CM. Control Unit > REMOVAL

Dtc b1436 air mix door actuator circuit open (passenger)
DTC DETECTING CONDITION:Air mix door actuator potentiometer circuit is open.TROUBLE SYMPTOM:Temperature of the passenger’s side cannot be adjusted for model with left/right independent air condi ...

Dtc b1434 evaporator temperature sensor circuit open
DTC DETECTING CONDITION:Evaporator sensor circuit is open.TROUBLE SYMPTOM:• Compressor does not operate.• Evaporator temperature is falsely recognized as low, and the compartment temperatu ...

Other materials:

Temperature control
Turn the temperature control dial over a range from the blue side (cool) to red side (warm) to regulate the temperature of airflow from the air outlets. MAX A/C mode Perform the following operation to select the MAX A/C mode.  Turn the temperature control dial to the "MAX A/C" posit ...

© 2017-2026 Copyright www.sulegacy.com