Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc b2790 id code box circuit

Subaru Legacy BN/BS (2015-2019) Service Manual / Keyless access with push button start system (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc b2790 id code box circuit

DTC DETECTING CONDITION:

An error has occurred inside the ID code box.

TROUBLE SYMPTOM:

Engine will not start.

CAUTION:

For replacement procedure of ID code box, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

STEP	CHECK	YES	NO
1.CHECK DTC. 1) Turn the ignition switch to OFF. 2) Using the Subaru Select Monitor, clear the memory of «keyless access with push button start». Clear Memory Mode 3) Turn the ignition switch to OFF > ON. 4) Register the ID code box. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume. 5) Read DTC using the Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)	Is DTC B2790 displayed-	Replace the ID code box. ID Code Box	ID code box registration was not performed properly.

Dtc b278a push engine switch power supply circuit

DTC DETECTING CONDITION:When the power supply circuit of the push button ignition switch is shorted to ground.TROUBLE SYMPTOM:• Engine does not start even when the access key is pointed toward t ...

Dtc b2789 id code box communication

DTC DETECTING CONDITION:• When communication between keyless access CM and ID code box is interrupted for a set amount of time.• Open or short circuit in the wiring harness between keyless ...

Other materials:

Front seat heater (if equipped)
Front seat heater switch HIGH mode indicator MID mode indicator LOW mode indicator Driver's side Front passenger's side Press the front seat heater switch. Each time you press the switch, the mode will change as follows. When LOW mode is select ...