Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc b2900 ahl control

Subaru Legacy BN/BS (2015-2019) Service Manual / Auto headlight beam leveler system (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc b2900 ahl control

DTC DETECTING CONDITION:

Detected when internal malfunction occurs in the auto headlight beam leveler CM.

TROUBLE SYMPTOM:

The auto headlight beam leveler does not operate.

CAUTION:

Initialization is required after replacing the auto headlight beam leveler CM.

STEP	CHECK	YES	NO
1.CHECK DTC. 1) Turn the ignition switch to OFF > ON. 2) Turn on the headlight low beam. 3) Using the Subaru Select Monitor, clear the auto headlight beam leveler system memory. Clear Memory Mode 4) Use the Subaru Select Monitor and read DTCs. Read Diagnostic Trouble Code (DTC)	Is DTC B2900 displayed- (current malfunction)	Replace the auto headlight beam leveler CM. Auto Headlight Beam Leveler Control Module	Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again. NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

Dtc b2902 rear height sensor circuit

DTC DETECTING CONDITION:Rear vehicle height sensor error is detected for 10 seconds or more.TROUBLE SYMPTOM:The auto headlight beam leveler does not operate.CAUTION:Initialization is required after re ...

Dtc u0122 lost communication with vehicle dynamics control module

Detected when CAN data (vehicle speed signal) is not received from VDC.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE ...

Other materials:

When the rear gate cannot be closed
CAUTION On areas which are not flat, such as hills, do not conduct any of the following actions. The rear gate may close suddenly and hit someone's head, face or catch fingers and body parts in it, resulting in injury. Even while conducting the foll ...