Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc p0512 starter (switch) request circuit

Subaru Legacy BN/BS (2015-2019) Service Manual / Engine (diagnostics)(h6do) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc p0512 starter (switch) request circuit

DTC DETECTING CONDITION:

Immediately at fault recognition

TROUBLE SYMPTOM:

Failure of engine to start

CAUTION:

After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.

WIRING DIAGRAM:

Engine Electrical System ENGINE TYPE EZ (WITH PUSH BUTTON START) Engine Electrical System > WIRING DIAGRAM

STEP	CHECK	YES	NO
1.CHECK PUSH BUTTON IGNITION SWITCH. Operate the push button ignition switch.	Does it operate smoothly without catch-	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0512 STARTER (SWITCH) REQUEST CIRCUIT	Replace the push button ignition switch. Push Button Ignition Switch
2.CHECK DTC. 1) Clear the memory using the Subaru Select Monitor. Clear Memory Mode 2) Start and idle the engine for three minutes or more.	Is the same DTC as current diagnosis output-	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0512 STARTER (SWITCH) REQUEST CIRCUIT	Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again. NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
3.CHECK HARNESS BETWEEN ECM AND KEYLESS ACCESS CM. 1) Turn the ignition to OFF. 2) Disconnect the connector from ECM. 3) Turn the ignition to ON. 4) Measure the voltage between ECM connector and chassis ground. Connector & terminal (B134) No. 46 (+) — Chassis ground (−):	Is the voltage 10 V or more-	Repair the short circuit to power supply in harness between ECM connector and keyless access CM connector.	Repair the poor contact of ECM connector.

1. OUTLINE OF DIAGNOSIS

Detect abnormal continuity in the starter SW1.

Judge as ON NG when the starter SW 1 signal remains ON.

2. EXECUTION CONDITION

Secondary Parameters	Execution condition
Battery voltage	≥ 8 V
Engine speed	> 500 rpm

3. GENERAL DRIVING CYCLE

Perform the diagnosis continuously after starting the engine.

4. DIAGNOSTIC METHOD

If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.

Judgment Value

Malfunction Criteria	Threshold Value
Starter SW1 voltage	≥ Battery voltage - 0.6

Time Needed for Diagnosis: 30000 ms

Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.

Dtc p0604 internal control module random access memory (ram) error

DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Engine does not start.• Engine stalls.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode ...

Dtc p050b cold start ignition timing performance

NOTE:For the diagnostic procedure, refer to DTC P050A. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P050A COLD START IDLE CONTROL SYSTEM PERFORMANCE1. OUTLINE OF DIAGNOSISNOTE:For th ...

Other materials:

Inspection
• Inspect the drive plate facing for wear and damage.• Driven plate for discoloration (burned color)• Make sure the snap ring is not worn and the return spring has no permanent distortion, damage, or deformation.• Check the lip seal for damage.• Inspect the extension en ...