Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc p0601 internal control module memory checksum error

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc p0601 internal control module memory checksum error

DTC DETECTING CONDITION:

Detected when two consecutive driving cycles with fault occur.

TROUBLE SYMPTOM:

TCM ROM malfunction

STEP	CHECK	YES	NO
1.CHECK DTC. 1) Perform the Clear Memory Mode using the Subaru Select Monitor. Clear Memory Mode 2) Read the DTC.	Is DTC P0601 displayed-	Replace the TCM. Transmission Control Module (TCM) Transmission Control Module (TCM)	Current condition is normal. Check for interference from noise, etc.

1. OUTLINE OF DIAGNOSIS

• Judge the malfunction in ROM area of the TCM.

• Judge as NG when the consistency in the ROM area is lost.

2. EXECUTION CONDITION

Secondary Parameters	Execution condition
12 V battery system voltage	≥ 9 V

3. DIAGNOSTIC METHOD

If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.

Judgment Value

Malfunction Criteria	Threshold Value
Checksum (ROM)	Error

Time Needed for Diagnosis: Immediately

Malfunction Indicator Light Illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.

Dtc p0705 transmission range sensor "a" circuit (prndl input)

DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Shift characteristics are erroneous.• The range position of the select lever and the position of shift indicator d ...

Dtc p2530 ignition switch run position circuit

DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Faulty TCM operationWIRING DIAGRAM:• ENGINE TYPE FBCVT control system CVT Control System > WIRING DIAGRAM• ENGINE T ...

Other materials:

Dtc p2127 throttle/pedal position sensor/switch "e" circuit low
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Improper idling• Poor driving performanceCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM: ...