Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc p0801 reverse inhibit control circuit/open
DTC DETECTING CONDITION: Immediately at fault recognition NOTE: For diagnostic procedures, refer to “BODY CONTROL SYSTEM (DIAGNOSTICS)”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1016 SHIFT LOCK CIRCUIT 1. OUTLINE OF DIAGNOSIS • Detect the malfunction of shift lock solenoid or circuit. • Judge as NG if abnormal signal from the integrated unit is received, when bus off is not detected and there is no trouble in CAN between the integrated unit. 2. EXECUTION CONDITION
3. DIAGNOSTIC METHOD If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
Time Needed for Diagnosis: 1 second |
Dtc p0842 transmission fluid pressure sensor/switch "a" circuit low
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Shift characteristics malfunction1. ENGINE TYPE FBWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPCHEC ...
Dtc p0776 pressure control solenoid "b" performance/stuck off
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Engine speed increases abruptly, and can not accelerate.• Excessive slippage is felt ...
Other materials:
Disassembly
1. Remove the reservoir tank.CAUTION:Be careful not to tighten a vise excessively.(1) Place the master cylinder assembly between aluminum plates and fix it on a vise.(2) Drive out the pin using a punch and a hammer to remove the reservoir tank.2. Remove the seal from the cylinder body assembly. ...
