Subaru Legacy BN/BS (2015-2019) Service Manual: Preparation tool

Subaru Legacy BN/BS (2015-2019) Service Manual / Rear suspension / General description / Preparation tool

1. SPECIAL TOOL

ILLUSTRATION	TOOL NUMBER	DESCRIPTION	REMARKS
	20099AE000	INSTALLER & REMOVER	Used for replacing the bushing B - lateral link.
	499755602	PRESS	Used for replacing the bushing - rear trailing link.
	20099AE010	INSTALLER & REMOVER	Used for replacing the bushing C - lateral link rear.
	20299AG010	BASE	Used for replacing the rear trailing link bushing.
	899874100	INSTALLER	Used for replacing the rear trailing link bushing.
	20399FG000	STRUT MOUNT SOCKET	• Used for removing and installing shock mount - rear. • Used for checking torque of shock mount center nut.
	28099PA090	OIL SEAL PROTECTOR	• Used for installing the rear drive shaft to the rear differential. • Used for oil seal protection.
	20099PA010	INSTALLER & REMOVER	• Used for replacing the bushing of the rear housing. • Used together with BUSHING REMOVER (20099FG000).
	20099FG000	BUSHING REMOVER	• Used for replacing the bushing of the rear housing. • Used together with base part of INSTALLER & REMOVER (20099PA010).

2. GENERAL TOOL

TOOL NAME	REMARKS
Alignment tester	Used for measuring wheel alignment.
Toe-in gauge	Used for toe-in measurement.
Jack	Used for removing and installing suspension.
Bearing puller	Used for removing bushings.
Tie-rod ball joint puller	Used for disconnecting the lateral link assembly - front.
Coil spring compressor	Used for disassembling and assembling strut assembly and shock absorber assembly.

Caution

• When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.• When disposing of shock absorber ...

Component

1. REAR SUSPENSION(1)Rear sub frame ASSY(11)Support - sub frameTightening torque: N·m (kgf-m, ft-lb)(2)Rear sub frame stopper upper (sedan model)(12)Flange nutT1:33 (3.4, 24.3)(3)Rear sub frame ...

Other materials:

Dtc p0024 "b" camshaft position - timing over-advanced or system performance bank 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Engine stalls.• Improper idlingCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCE ...