Subaru Legacy BN/BS (2015-2019) Service Manual: Caution

• When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.

• When disposing of shock absorbers, be sure to bleed the oil or gas out completely. Also, do not expose to flames or fire.

• When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.

• Use SUBARU genuine grease, the recommended or equivalent. Do not mix grease etc. of different grades or manufacturers.

• Do not secure a part in a vise directly. Place cushioning materials such as wood blocks, aluminum plates, or waste cloth between the part and the vise.

• Be sure to tighten fasteners including bolts and nuts to the specified torque.

• Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.

• When the suspension-related components have been removed or replaced, perform “VDC sensor midpoint setting mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT

• For parts which are not reusable, always use new parts. Other parts should be replaced with new parts as required.

• When handling oil or fuel, adhere to the following to prevent unexpected accident.

• Be sure that the surface of brake disc or brake pad is free from grease or oil.

• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery.

• Some vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.