Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc u0101 lost communication with tcm

Subaru Legacy BN/BS (2015-2019) Service Manual / Engine (diagnostics)(h4do) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc u0101 lost communication with tcm

NOTE:

For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure

1. OUTLINE OF DIAGNOSIS

Detect malfunction of CAN communication.

Judge as NG when CAN communication failure between TCM, VDC CM and combination meter has occurred.

2. COMPONENT DESCRIPTION

(Common Specifications)

CAN Protocol 2.0 B (Active)

Frame Format: 11 Bit ID Frame (Standard Frame)

Conforms to ISO11898

Communication Speed: 500 kbps

3. EXECUTION CONDITION

Secondary Parameters	Execution condition
Battery voltage	≥ 10.9 V

4. GENERAL DRIVING CYCLE

Always perform the diagnosis continuously.

5. DIAGNOSTIC METHOD

Judge as NG when the following conditions are established.

Judgment Value

Malfunction Criteria	Threshold Value
Data from control modules connected to CAN	None

Time Needed for Diagnosis: 500 ms

Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.

Dtc p0125 insufficient coolant temperature for closed loop fuel control

DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:Engine does not return to idle.CAUTION:After servicing or replacing faulty parts, perform Clear Me ...

Dtc u1712 lost lin communication with battery "1" monitor module

DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mod ...

Other materials:

Replacement
CAUTION:• If there was so much rust in the rear differential mount bushing, remove the rust before starting work.• Apply the molybdenum grease on the square thread of the ST (shaft and nut) before use.1. Remove the rear differential. Rear Differential (T-type) > REMOVAL Rear Differenti ...