Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc u0140 lost communication with body control module

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc u0140 lost communication with body control module

NOTE:

Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedure. Basic Diagnostic Procedure

1. OUTLINE OF DIAGNOSIS

• Detect malfunction of CAN communication.

• Judge as NG when CAN communication failure occurs with the body integrated unit.

2. EXECUTION CONDITION

Secondary Parameters	Execution condition
Turbine shaft speed	> 0 rpm
or
D range switch	ON

3. DIAGNOSTIC METHOD

If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.

Judgment Value

Malfunction Criteria	Threshold Value
CAN data from BIU	Lost

Time Needed for Diagnosis: 2 seconds

Dtc p0500 vehicle speed sensor "a" circuit

DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:VDC does not operate.STEPCHECKYESNO1.CHECK DTC.Read the DTC of VDC system using the Subaru Select Monitor.Is DTC displayed-Perfo ...

Dtc u0122 lost communication with vehicle dynamics control module

NOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedure. Basic Diagnostic Procedure1. OUTLINE OF DIAGNOSIS (ENGINE TYPE FB)• Detect malfunction of CAN communication.• ...

Other materials:

Removal
1. RH SIDE1. Remove the collector cover.(1) Carefully pull up the rear of collector cover at two positions (A).(2) Carefully pull up the front of collector cover at two positions (B) while moving it forward.2. Release the fuel pressure. Fuel > PROCEDURE3. Disconnect the ground terminal from battery ...