Subaru Legacy BN/BS (2015-2019) Service Manual: Electrical component location location

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission (diagnostics) / Electrical component location location

1. CONTROL MODULE

(1)	TCM (engine type FB)	(3)	AT OIL TEMP light	(4)	AWD light
(2)	TCM (engine type EZ)

2. SENSOR

• ENGINE TYPE FB

(1)	Secondary speed sensor	(3)	Primary speed sensor	(5)	Inhibitor switch
(2)	Turbine speed sensor	(4)	Secondary pressure sensor

• ENGINE TYPE EZ

(1)	Secondary speed sensor	(3)	Primary speed sensor	(5)	Inhibitor switch
(2)	Front wheel speed sensor	(4)	Secondary pressure sensor

3. SOLENOID

• ENGINE TYPE FB

(1)	Secondary solenoid	(3)	Lock-up duty solenoid	(5)	Primary UP solenoid
(2)	AWD solenoid	(4)	Primary DOWN solenoid	(6)	F&R solenoid

• ENGINE TYPE EZ

(1)	Secondary solenoid	(4)	Primary DOWN solenoid	(6)	F&R solenoid
(2)	AWD solenoid	(5)	Primary UP solenoid	(7)	Lock-up ON/OFF solenoid
(3)	Lock-up duty solenoid

Drive cycle procedure

It is possible to complete diagnosis of the DTC by performing the indicated drive cycle. After the repair for the DTC, perform a necessary drive cycle and make sure the function recovers and the DTC i ...

Inspection mode procedure

Road Test Road Test ...

Other materials:

Removal
1. INTAKE SIDE1. Remove the collector cover.(1) Carefully pull up the rear of collector cover at two positions (A).(2) Carefully pull up the front of collector cover at two positions (B) while moving it forward.2. Disconnect the ground terminal from battery sensor. NOTE3. Remove the fuel injector. ...