Subaru Legacy BN/BS (2015-2019) Owners Manual: Engine coolant

Subaru Legacy BN/BS (2015-2019) Owners Manual / Maintenance and service / Cooling system / Engine coolant

Checking the coolant level

Checking the coolant level

1) "FULL" level mark
2) "LOW" level mark

Check the coolant level at each fuel stop.

Check the coolant level on the outside of the reservoir while the engine is cool.
If the level is close to or lower than the "LOW" level mark, add coolant up to the "FULL" level mark. If the reserve tank is empty, remove the radiator cap and refill as required.
After refilling the reserve tank and the radiator, reinstall the caps and check that the rubber gaskets inside the radiator cap are in the proper position.

CAUTION

Be careful not to spill engine coolant when adding it. If coolant touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. If engine coolant gets on the exhaust pipe, be sure to wipe it off.
Do not splash the engine coolant over painted parts. The alcohol contained in the engine coolant may damage the paint surface.

Changing the coolant

It may be difficult to change the coolant.

Have the coolant changed by your SUBARU dealer if necessary.

The coolant should be changed according to the maintenance schedule in the "Warranty and Maintenance Booklet".

Cooling fan, hose and connections

Your vehicle employs an electric cooling fan which is thermostatically controlled to operate when the engine coolant reaches a specific temperature. 1) Normal operating range If the radiator ...

Air cleaner element

WARNING Do not operate the engine with the air cleaner element removed. The air cleaner element not only filters intake air but also stops flames if the engine backfires. If the ...

Other materials:

Read diagnostic trouble code (dtc) operation
1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, select «Keyless Access with Push Button Start» and then select «Ent ...