Subaru Legacy BN/BS (2015-2019) Owners Manual: If you have accidentally triggered the alarm system

Subaru Legacy BN/BS (2015-2019) Owners Manual / Keys and doors / Alarm system / If you have accidentally triggered the alarm system

To stop the alarm

Perform any of the following operations.

Press any button on the access key/ remote transmitter.
Turn the ignition switch to the "ON" position (models without "keyless access with push-button start system").
Turn the push-button ignition switch to the "ACC" position (models with "keyless access with push-button start system").

NOTE Only registered keys will stop the alarm. If the key is not registered, the alarm will not stop.

Activating and deactivating the alarm system

To change the setting of your vehicle's alarm system for activation or deactivation, do the following. Disarm the alarm system. Refer to "Disarming the system" . Sit in the drive ...

Arming the system

NOTE The system can be armed even if the engine hood, the windows and/or moonroof are open. Always make sure that they are fully closed before arming the system. When arming ...

Other materials:

Dtc b1648 side satellite sensor bus lh initialization error
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Side sensor LH bus line communication initialization error (open/short circuit or connector connection failure between airbag CM and side airbag sensor LH, open/short circuit or connector connection failure between si ...