Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Brake / Front brake pad / Inspection

1. Check the thickness (A) of the pad - disc brake front.

NOTE:

• Always replace the pads of both wheels and both sides as a set.

• Replace pad clips if they are twisted or worn.

• Replace the pad if there is oil or grease on it.

• Wear indicators are installed on the pad - disc brake front inner and the pad - disc brake front outer, and a squeaking sound is heard if the pad is worn to the limit.

	Brake pad type	Standard (A)	Wear limit (B)
Pad thickness	16-inch type	12 mm (0.47 in)	1.5 mm (0.059 in)
Pad thickness	17-inch type	11 mm (0.43 in)	1.5 mm (0.059 in)

2. If the wear limit is exceeded in the inspection, replace the pad - disc brake front. Front Brake Pad > REPLACEMENT

Replacement

1. Remove the pad - disc brake front.• 16-inch type: Front Brake Pad > REMOVAL• 17-inch type: Front Brake Pad > REMOVAL2. Press back the piston - disc brake.3. Install the pad - disc bra ...

1. 16-INCH TYPE1. Lift up the vehicle, and then remove the front wheels.2. Remove the pad - disc brake front.NOTE:Do not disconnect the brake hose from the caliper body assembly.(1) Remove the caliper ...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trunk trim panel assembly - side on the RH side. (Sedan model) Rear Quarter Trim > REMOVAL3. Remove the right side rear quarter trim. (OUTBACK model) Rear Quarter Trim > REMOVAL4. Remove the fuel pump control unit.• Se ...