Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
1. BATTERY Check the battery. Battery > INSPECTION Battery > INSPECTION Standard voltage: 12 V or more Specific gravity: 1.260 or more 2. TRANSMISSION GROUND Make sure that the ground terminal bolt is tightened securely. Tightening torque: ENGINE TYPE FB 14 N·m (1.4 kgf-m, 10.3 ft-lb)
ENGINE TYPE EZ 16 N·m (1.6 kgf-m, 11.8 ft-lb)
3. OPERATION OF SELECT LEVER Make sure there is no noise, dragging or contact pattern in each select lever range. WARNING: Stop the engine while checking operation of the select lever. |
Caution
1. The airbag system wiring harness is routed near the TCM.CAUTION:• All the airbag system wiring harnesses and connectors are colored yellow. Do not use an electric test equipment to check thes ...
Learning control
...
Other materials:
Dtc p0020 "a" camshaft position actuator control circuit/open bank 2
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Improper idlingCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE ...
