Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr580) / Reverse brake assembly / Inspection

• Inspect the drive plate facing for wear and damage.

• Check the driven plate for discoloration (burnt color).

• Check for worn snap ring, fatigue or damaged return spring or deformed spring retainer.

• Make sure the clearance between retaining plate and snap ring of reverse brake is within the limit. If it exceeds the limit, replace with a new drive plate and select and adjust the retaining plate within the initial standard value. Reverse Brake Assembly > ASSEMBLY

Installation

1. Select a washer. Forward Clutch Assembly > ADJUSTMENT2. Install the selected washer to the reverse brake housing.3. Install the thrust bearing to the reverse brake housing.NOTE:Face the temper col ...

Disassembly

1. Remove the snap ring.2. Remove the retaining plate, drive plate, driven plate and dish plate.3. Compress the return spring using the ST to remove the snap ring.ST 18762AA001COMPRESSOR SPECIAL TO ...

Other materials:

Dtc u0077 lin communication bus "ecm/pcm" off
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE EZ (WITHOUT PUSH BUTTON ST ...