Subaru Legacy BN/BS (2015-2019) Service Manual: Continuously variable transmission(tr580)
Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr580)
- Diagnostics with phenomenon inspection
- Road test inspection
- Secondary pressure (line pressure) test inspection
- Stall test inspection
- Time lag test inspection
- Transfer clutch pressure test inspection
- Air breather hose
- Automatic transmission assembly
- Awd on off switching mode
- Control valve body
- Converter case
- Cvtf
- Cvtf cooler (air cooling)
- Cvtf cooler (with warmer function)
- Cvtf cooler pipe and hose
- Cvtf filter
- Differential gear oil
- Differential side retainer oil seal
- Drive pinion shaft assembly
- Drive plate
- Extension case
- Extension case oil seal
- Forward clutch assembly
- Front differential assembly
- General description
- Inhibitor switch
- Oil pan and strainer
- Oil pump
- Oil pump chain
- Parking pawl
- Preparation for overhaul
- Primary pulley and secondary pulley
- Primary speed sensor
- Reduction drive gear
- Reduction driven gear
- Relay and fuse
- Reverse brake assembly
- Secondary pressure sensor
- Secondary speed sensor
- Torque converter assembly
- Transfer clutch
- Transfer driven gear
- Transmission case
- Transmission control device
- Transmission control module (tcm)
- Transmission harness
- Transmission mounting system
- Turbine speed sensor
- Variator chain
- X mode switch
Electrical specification
• ENGINE TYPE FBNOTE:Measure after warming up.ItemTerminal No.Measuring conditionMeasurement valueResistance between terminal and chassis groundRemarksBackup power supply34 — 10 — 13 V — ...
Diagnostics with phenomenon inspection
SymptomsFaulty partsStall speed is low after warming-up, with select lever in “D” or “R” range.Engine control systemVehicle does not move despite engine speed rising up, with s ...
Other materials:
Removal
1. SEDAN MODEL1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trunk trim panel - side. Trunk Room Trim > REMOVAL3. Remove the rear side marker light bulb. Rear Combination Light Assembly > DISASSEMBLY2. OUTBACK MODEL1. Disconnect the ground terminal from battery sensor. ...
© 2017-2026 Copyright www.sulegacy.com
