Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
• Check the forward clutch drum, internal gear, sun gear and forward clutch piston lip for wear or damage. • Inspect the drive plate facing for wear and damage. • Check the driven plate for discoloration (burnt color). • Check for worn snap ring, fatigue or damaged return spring or deformed spring retainer. • Make sure the clearance between retaining plate and internal gear of forward clutch is within the limit. If it exceeds the standard, replace the forward clutch. Forward Clutch Assembly > ASSEMBLY |
Installation
1. Install the thrust bearing to the converter case.NOTE:Face the temper color surface to the converter case side.2. Install the seal ring to the input shaft.NOTE:• Use new seal rings.• Wh ...
Disassembly
1. FORWARD CLUTCH ASSEMBLY1. Remove the snap ring.2. Remove the retaining plate, drive plate, driven plate and dish plate.3. Compress the return spring using the ST to remove the snap ring.ST1 1876 ...
Other materials:
Dtc p2195 a/f /o2 sensor signal biased/stuck lean bank 1 sensor 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...
