Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part. • After installing the secondary pressure sensor, adjust the CVTF level. 1. Install the secondary pressure sensor. NOTE: • Use new O-rings. • Apply CVTF to the O-rings. Tightening torque: 39 N·m (4.0 kgf-m, 28.8 ft-lb) 2. Connect the harness connector. 3. Lower the vehicle. 4. Connect the ground terminal to battery sensor. NOTE 5. Refill CVTF to adjust the CVTF level. CVTF |
Inspection
1. Start and warm up the engine.2. Depress the brake pedal, and shift the select lever to “D” range.3. Shift the select lever to “P” or “N” range.4. Depress the bra ...
Other materials:
Dtc p2419 evap system switching valve control circuit low
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE FB (WITHOUT PUSH BUTTON ST ...
