Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
1. Start and warm up the engine. 2. Depress the brake pedal, and shift the select lever to “D” range. 3. Shift the select lever to “P” or “N” range. 4. Depress the brake pedal and hold it. 5. Check “secondary pressure sensor voltage” by using Subaru Select Monitor while the engine is idling. Subaru Select Monitor > OPERATION Specification: Approx. 0.8 V 6. Check “secondary pressure sensor voltage” with engine stopped and ignition switch turned on by using Subaru Select Monitor. Subaru Select Monitor > OPERATION Specification: Approx. 0.5 V |
Removal
CAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.• When secondary pressure sensor ...
Installation
CAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.• After installing the secondary ...
Other materials:
Removal
CAUTION:Always use new MT gear select cable if the cable is removed from selector lever COMPL of transmission side.1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the air intake duct. Air Intake Duct > REMOVAL3. Remove the V-belt covers.4. Remove the clip (A) from the air inta ...
