Pressing the Vehicle Dynamics Control OFF switch deactivates the Vehicle Dynamics Control system. Creating an adequate driving wheel slip by deactivating the Vehicle Dynamics Control system temporarily may help to escape from the following situations. Use the Vehicle Dynamics Control OFF switch as necessary. . a standing start on a steeply sloping road with a snowy, gravel-covered, or otherwise slippery surface . extrication of the vehicle when its wheels are stuck in mud or deep snow When the switch is pressed during engine operation, the Vehicle Dynamics Control OFF indicator light on the combination meter illuminates. The Vehicle Dynamics Control system will be deactivated. When the switch is pressed again to reactivate the Vehicle Dynamics Control system, the Vehicle Dynamics Control OFF indicator light turns off. You should not deactivate the Vehicle Dynamics Control system except under the above-mentioned situations
NOTE
|
Vehicle Dynamics Control system monitor
X-mode (Outback CVT models)Dtc p013c o2 sensor slow response - rich to lean bank 2 sensor 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...