Subaru Legacy BN/BS (2015-2019) Owners Manual: Starting and operating
Subaru Legacy BN/BS (2015-2019) Owners Manual / Starting and operating
- Fuel
- State emission testing (U.S. only)
- Preparing to drive
- Starting and stopping the engine (models without push-button ignition switch)
- Starting and stopping engine (models with push-button start system)
- Remote engine start system (dealer option)
- Models with "keyless access with push-button start system"
- Models without "keyless access with push-button start system"
- Entering the vehicle while it is running via remote start
- Entering the vehicle following remote engine start shutdown
- Service mode (models without "keyless access with push-button start system")
- Remote transmitter program (models without "keyless access with push-button start system")
- System maintenance
- Manual transmission
- Continuously variable transmission
- Power steering
- Braking
- ABS (Anti-lock Brake System)
- Electronic Brake Force Distribution (EBD) system
- X-mode (Outback CVT models)
- Tire pressure monitoring system (TPMS) (if equipped)
- Parking your vehicle
- Hill start assist system (MT models)
- Cruise control
- To set cruise control
- To temporarily cancel the cruise control
- To turn off the cruise control
- To change the cruising speed
- BSD/RCTA (if equipped)
- System features
- System operation
- BSD/RCTA approach indicator light/warning buzzer
- BSD/RCTA warning indicator
- BSD/RCTA OFF switch
- Certification for the BSD/RCTA
- Handling of radar sensors
- Reverse Automatic Braking System (if equipped)
Help line
The help line (distance marker and vehicle
width line) is a guide to help you realize
the actual distance from the screen.
Help lines
1) Vehicle width line (oblique vertical line)
2) Approx. 10 ...
Fuel
CAUTION
Use of a fuel which is low in quality
or use of an inappropriate fuel
additive may cause damage to the
engine and/or fuel system.
...
Other materials:
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - rear door. Door Trim > REMOVAL3. Remove the sealing cover - rear door. Rear Sealing Cover > REMOVAL4. Connect the ground terminal to battery sensor. NOTE5. Remove the glass assembly - rear door.(1) Install the ...
© 2017-2024 Copyright www.sulegacy.com
