Subaru Legacy BN/BS (2015-2019) Owners Manual: Certification for the BSD/RCTA

Subaru Legacy BN/BS (2015-2019) Owners Manual / Starting and operating / BSD/RCTA (if equipped) / Certification for the BSD/RCTA

U.S.-spec. models

FCC ID: OAYSRR2A

CAUTION FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Canada-spec. models

This device complies with Industry Canada licence-exempt RSS standard (s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

BSD/RCTA OFF switch

BSD/RCTA OFF switch BSD/RCTA OFF indicator If the BSD/RCTA OFF switch is pressed, the BSD/RCTA OFF indicator appears on the multi information display of the combination meter, and the BSD ...

Handling of radar sensors

Radar sensors (Legacy) Radar sensors (Outback) The radar sensors, one on each side of the vehicle, are mounted inside the rear bumper CAUTION To ensure correct operation of ...

Other materials:

Dtc p2610 ecm/pcm engine off timer performance
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.STEPCHECKYESNO1.CHECK FOR ANY OTHER DTC ON DISPLAY.Is an ...