Subaru Legacy BN/BS (2015-2019) Owners Manual: Remote engine start system (dealer option)

Subaru Legacy BN/BS (2015-2019) Owners Manual / Starting and operating / Remote engine start system (dealer option)

WARNING

There are some general precautions when starting the engine.
Carefully read the precautions described in "General precautions when starting/stopping engine" .
Do not remote start a vehicle in an enclosed environment (e.g.
closed garage). Prolonged operation of a motor vehicle in an enclosed environment can cause a harmful build-up of Carbon Monoxide. Carbon Monoxide is harmful to your health. Exposure to high levels of Carbon Monoxide can cause headaches, dizziness or in extreme cases unconsciousness and/or death.
Before performing any servicing of the vehicle, temporarily place the remote engine start system in service mode to prevent the system from unexpectedly starting the engine.

The remote engine start system allows you to start the engine from outside the vehicle. In addition, the remote engine start system can activate the heater or air conditioner, providing you with a comfortable cabin upon entry.

NOTE The length of time for which it is acceptable to allow the engine to remain idling may be bound by local laws and regulations. Check the local rules when using the remote engine start system.

Steering lock

After stopping the engine and the driver's door is open, the steering wheel will be locked due to the steering lock function. When the engine is restarted, the steering lock will be automaticall ...

Models with "keyless access with push-button start system"

NOTE For more details, refer to the Owner's Manual supplement for the remote engine start system. Access key 1) Lock button An access key can be used as the remote engine start transmitter. ...

Other materials:

Inspection
1. LATCHCheck if the latch operates normally.If the cable is faulty, replace the latch & actuator assembly - rear.2. ACTUATOR1. Check door lock operationCheck the door lock operation when battery voltage is applied between the connectors.Terminal No.Inspection conditionsStandard4 (+) — 1 (−) ...