Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr580) / Turbine speed sensor / Installation

CAUTION:

Be sure to prevent water or oil from contacting the connector terminal of turbine speed sensor. If adhesion occurs, replace with a new part.

1. Install the turbine speed sensor.

NOTE:

• Use new O-rings.

• Apply CVTF to the O-rings.

Tightening torque:

7 N·m (0.7 kgf-m, 5.2 ft-lb)

2. Connect the harness connector.

3. Lower the vehicle.

4. Connect the ground terminal to battery sensor. NOTE

Inspection

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the clip (A), and loosen the clamps (B) and (C).3. Remove the air intake boot from the throttle body, and move it to the left side ...

Variator chain

...

Other materials:

Off road driving
WARNING Always maintain a safe driving speed according to the road and weather conditions in order to avoid having an accident on a sharp turn, during sudden braking or under other similar conditions. Always use the utmost care in driving - overconf ...