Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr580) / Secondary speed sensor / Installation

CAUTION:

• Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part.

• After installing the secondary speed sensor, adjust the CVTF level.

1. Install the secondary speed sensor.

NOTE:

• Use new O-rings.

• Apply CVTF to the O-rings.

Tightening torque:

7 N·m (0.7 kgf-m, 5.2 ft-lb)

2. Connect the harness connector.

3. Lower the vehicle.

4. Connect the ground terminal to battery sensor. NOTE

5. Refill CVTF to adjust the CVTF level. CVTF

Inspection

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the clip (A), and loosen the clamps (B) and (C).3. Remove the air intake boot, and move it to the left side wheel apron.4. Disconn ...

Torque converter assembly

...

Other materials:

Removal
Refer to “DISASSEMBLY” for removal procedures of scalp cap and mirror face. Outer Mirror Assembly > DISASSEMBLY1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel - front door. Door Trim > REMOV ...