Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Differentials / Differential gear oil / Inspection

1. Lift up the vehicle.

2. Remove the filler plug, and then check the gear oil. Replace the gear oil if it is contaminated, deteriorated or cloudy. Differential Gear Oil > REPLACEMENT

3. Check that the gear oil level is within −5 mm (−0.2 in) from the bottom of the filler plug hole. If the level is low, make sure that there is no oil leakage and refill up to the bottom of filler plug hole.

NOTE:

On VA1-types at factory settings, the oil level may be within −14 mm (−0.6 in) from the bottom of the filler plug. This is at normal level, requiring no oil refill.

• T-type

(A)	Filler plug

• VA1-type

(A)	Filler plug

• VA2-type

(A)	Filler plug

4. Install the filler plug.

NOTE:

• For the T-type, degrease the thread portion sufficiently and apply liquid gasket to the filler plug.

Liquid gasket:

THREE BOND 1105 (Part No. 004403010) or equivalent

• For VA type, use a new gasket.

Tightening torque:

T-type:

49 N·m (5.0 kgf-m, 36.1 ft-lb)

VA-type:

50 N·m (5.1 kgf-m, 36.9 ft-lb)

Replacement

CAUTION:• Gear oil is extremely hot just after driving. Be wary of receiving burns.• Be careful not to spill the differential gear oil on exhaust pipe. If gear oil is spilled, wipe it off ...

General description

...

Other materials:

Dtc p0430 catalyst system efficiency below threshold bank 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Engine stalls.• Idle mixture is out of specifications.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode ...