Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
1. Moving the front tire up and down by hand, check there is no play in bearing, and check the wheel rotates smoothly. CAUTION: If there is any fault in the bearing, replace the hub unit COMPL.
2. Inspect axial play of the hub unit bearing. (1) Remove the tire and disc rotor. (2) Inspect the lean of axis direction using a dial gauge. Replace the hub unit COMPL if the play exceeds the limit. Service limit: Maximum: 0.05 mm (0.0020 in)
|
Installation
1. Tighten the back plate - front brake and the hub unit COMPL - front axle to the housing assembly - front axle with bolts.CAUTION:• Do not get closer the tool which charged magnetism to magnet ...
Disassembly
Using the ST or a hydraulic press, push out the bolt - hub (b) from the hub unit COMPL - front axle (a).CAUTION:• Be careful not to hammer the bolts - hub. This may deform the hub unit COMPL.&bu ...
Other materials:
Dtc p2099 post catalyst fuel trim system too rich bank 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...
