Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Eyesight / Relay and fuse / Inspection

1. CHECK FUSE

1. Remove the fuse and inspect visually.

2. If the fuse is blown out, replace the fuse.

NOTE:

If the fuse is blown again, check the system wiring harness.

2. CHECK RELAY

1. Measure the resistance between relay terminals.

Terminal No.	Inspection conditions	Standard	Circuit
1 — 2	Always	1 M- or more
1 — 4	Always	Less than 1 -
1 — 2	Apply battery voltage between terminals 3 and 5.	Less than 1 -

2. Replace the relay if the inspection result is not within the standard value.

Location

Main fuse box (M/B)Brake light relay(A)Fuse & relay box (F/B)Fuse 7.5 A (stop light and brake switch)(B)Fuse 7.5 A (stereo camera)(C)NOTE:For other related fuses, refer to the wiring diagram. Power S ...

Stereo camera

...

Other materials:

Dtc p0420 catalyst system efficiency below threshold bank 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Engine stalls.• Idle mixture is out of specifications.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode ...