Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Door switch / Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.

Inspection conditions

Standard

Front LH: 1 — 2

Except for front LH: 1 — 4

When the switch is not pressed

Less than 1 -

When the switch is pressed

1 M- or more

2. Replace the switch assembly - door if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the switch assembly - door.(1) Remove the screws, and pull out the switch assembly - door toward you.(2) Disconnect the connector ...

Installation

1. Install the switch assembly - door.2. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Installation
1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.2. Close all the doors, trunk lid and rear gate.3. Press the UNLOCK button of the keyless transmitter or access key.4. Connect the ground terminal to battery sensor. NOTE5. Install the impact sensor.6. Change the setti ...