Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Hazard switch / Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
2 — 3	Switch OFF	1 M- or more
2 — 3	Switch ON	Less than 1 -

2. Apply battery voltage between the connector terminals to check the lighting condition of the light.

Terminal No.	Inspection conditions	Specification
4 (+) — 1 (−)	Apply battery voltage.	Light ON

3. Replace the switch - hazard if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the center grille assembly. Air Vent Grille > REMOVAL3. Release the claws, and then remove the switch - hazard. ...

CAUTION:After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.1. Install the switch - hazard.2. Install ...

Other materials:

Installation
1. SEDAN MODEL1. Install the light assembly - high-mounted.2. Install the trim panel assembly - rear shelf. Rear Shelf Trim > INSTALLATION3. Connect the ground terminal to battery sensor. NOTE2. OUTBACK MODELCAUTION:Make sure the bolt is tightened securely because improper roof spoiler installatio ...