Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Light control sensor / Inspection

1. Connect the connector.

2. Turn the ignition switch to ON, and set the lighting switch to the AUTO position.

3. Measure the voltage between connector terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
2 (+) — 1 (−)	Measure the voltage when the area around the sensor - automatic light, which was dark, becomes bright.	Dark condition: Approx. 0.6 V or less
2 (+) — 1 (−)		Bright condition: Approx. 3.0 V or more

4. Replace the sensor - automatic light if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - front pillar UPR. Upper Inner Trim > REMOVAL3. Release the clips and claws, then detach the grille speaker side. ...

Installation

1. Install the sensor - automatic light.2. Install the duct - front defroster.3. Install the grille speaker side.4. Install the trim panel - front pillar UPR. Upper Inner Trim > INSTALLATION5. Connec ...

Other materials:

Power door locking switches
Lock Unlock All doors and the rear gate (Outback) can be locked and unlocked by the power door locking switches located at the driver's side and the front passenger's side doors. To lock the doors, press the front side of the switch. To unlock the doors, press the rear si ...