Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Mechanical(h4do) / Engine assembly / Inspection

1. Check that pipes, hoses, connectors and clamps are installed firmly.

2. Check the engine coolant is at specified level.

3. Start the engine and check for exhaust gas, engine coolant, leaks of fuel, etc. Also check for noise and vibrations.

Removal

1. Fully open the front hood. NOTE2. Remove the V-belt covers.3. Collect the refrigerant. Refrigerant Recovery Procedure4. Release the fuel pressure. Fuel > PROCEDURE5. Open the fuel filler lid and ...

Installation

1. Apply a small amount of grease to splines of main shaft. (MT model)Grease:NICHIMOLY N-130 or equivalent2. Position the engine in engine compartment and align it with transmission.NOTE:Be careful no ...

Other materials:

Removal
1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL3. Remove the power rear gate control module (PRG CM).(1) Disconnect the connectors in the following order.1: D ...