Subaru Legacy Service Manual: Mechanical(h4do)
Subaru Legacy Service Manual / Mechanical(h4do)
- Compression inspection
- Connecting rod specification
- Crankshaft specification
- Engine noise inspection
- Engine oil pressure inspection
- Engine trouble in general inspection
- Fuel pressure inspection
- Idle speed inspection
- Ignition timing inspection
- Intake and exhaust valve specification
- Intake manifold vacuum inspection
- Piston specification
- Preparation for overhaul procedure
- Cam carrier
- Cam clearance
- Cam sprocket
- Camshaft
- Chain cover
- Crank pulley
- Crank sprocket
- Cylinder block
- Cylinder head
- Engine assembly
- Engine mounting
- General description
- Rocker cover
- Timing chain assembly
- V-belt
Installation
1. CROSSMEMBER AND CUSHION RUBBER1. Install the transmission cushion rubber to the transmission, and tighten the bolt (A).2. Install the transmission cushion rubber to the center crossmember, and temp ...
Compression inspection
CAUTION:After warming-up, engine becomes very hot. Be careful not to burn yourself during measurement.NOTE:• Before checking the compression pressure, the compression condition of each cylinder ...
Other materials:
Dtc b1832 short in curtain airbag rh squib circuit (to ground)
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:GND short circuit failure (shorted to ground in main harness, shorted to ground in curtain airbag RH, shorted to ground in airbag CM internal circuit)CAUTION:Before performing diagnosis, refer to “CAUTION” ...
© 2017-2023 Copyright www.sulegacy.com
